Catalogue

- or lifting, precise height adjustment and stabilising the pipe level relative to the upper reinforcement
- for bar thickness up to 4mm
- height depending on slab construction.
- Material : steel
- No. required : 4 per m²

- Patented element is designed that after concreting, the pipes can be pulled out under the ceiling slab and connected to the manifold or supply line below the ceiling.
- For pipes up to 20 mm.
- Stackable for alignement to other elements.
- A small red flag indicates pull direction of the pipe.
- Delived including nails for fixing to supports.
- Length: 540 mm
- Width: 39 mm
- Height: 29 mm
- Max. height: 57 mm (at the connection point)

- Allows monitoring the test pressure with color code
- Apply 4bar
- It shows green color while pressure is higher than 2 bar. Below 2 bar is turning yellow and later red.

- for the connection of additional, external cooling/heating or peak load elements
- With Q&E connection.
- Type 2

- To connect the thermal socket outside the concrete ceiling
- With 1/2" FT elbow connecton.
- Type 2

- To connect the thermal socket outside the concrete ceiling
- With Push 15 elbow connecton with possibility to adapt Uponor actuator
- Type 2

- for the connection of additional, external cooling/heating or peak load elements
- With 1/2" FT connection
- Type octogonal

- To connect the thermal socket outside the concrete ceiling
- With 1/2" FT elbow connecton.
- Type: octogonal

- empty modules without pipes
- for on-site installation of the piping

- PE-Xb
- Snow melting and surface heating.
- Max design temperature: 50°C
- Design pressure: 4,5 Bar at 50°C

- Single manifold

- Double manifold