Catalogue

- For concrete core hole or fibre cement pipe
- Part to eliminate radial stress of the casing pipe
- Used with Uponor wall seal PWP

- Enbed in a brick wall or concrete wall
- Alternative to water-proof concrete core hole
- Applicable for Uponor wall seal PWP (pressurized water)
- "Dimension" = used for jacket pipe diameter

- For concrete-cast and brick walls
- Applicable for NWP = no pressurized water area
- Contain PE pipe and shrink sleeve

- Conduit used for Ecoflex pipe enter through the base plate the building

- Guiding 90° the Ecoflex pipes in base floor penetration
- Metal support braces can be linked together

- Shrink sleeve to seal damages in casing pipe

- Shrinkable tape use for sealing damaged casing pipes

- For marking the position of buried Ecoflex pipes
- Tape marking with required application symbols

- Material to seal the insulation set.

RC version for domestic hot water and direct heating with radiator connection (no mixing circuit). Mixing circuit can be upgraded by using the dedicated cabinet with installed UFH mixing group (Uponor Combi Port M-Base Cabinet+manif IW-UFH). Bypass function can be upgraded by using special accessory - Uponor Combi Port M-Base Heat Bypass.
Dimensioning codes:
15,19 – domestic hot water capacity indication (l/min)
CB – copper brazed stainless steel heat exchanger for domestic hot water preparation
TL – thermostatic temperature limiter for domestic hot water with submersible sensor
ZV – zone valve in residential heating circuit return line without actuator
NI – no pipe insulation and/or insulated cover

In-wall mounted cabinet including feet, heating manifold, and rail with pre-installed ball valves and mixing circuit for extension of the Uponor Combi Port M-Base HeatInterface RC to UFH version.
Dimensioning codes:
HMV – set of Vario-S manifolds for heating with _ (4,6,8) heating circuits
BV – set of 7 ball valves pre-installed on the mounting rail inside the cabinet for heat interface connections
MS – mixing set with heating pump, thermostat, and non-return valve for apartment heating circuit

IH version for domestic hot water and indirect heating systems using second heat exchanger with heating circuit connections including heating pump and expansion tank mounted on the back of heat interface unit.
Dimensioning codes:
15, 21, 27 – domestic hot water capacity indication (l/min)
CB – copper brazed stainless steel heat exchanger for domestic hot water preparation
6D – all system connections in the bottom of heat interface unit
TL – thermostatic temperature limiter for domestic hot water with submersible sensor
ZV – zone valve in residential heating circuit return line without actuator
ZH – apartment heating circuit circulation arrangement, including circulation pump, thermostatic flow controller and expansion tank
CR – heat interface metal cover casing white powder coated (RAL 9016)
NI – no pipe insulation and/or insulated cover
NC – no cold water outlet from heat interface unit